Select the desired location on your car and clean it thoroughly with soap and water to remove any dirt and grease. Dry the surface with a clean microfiber cloth and if there is any residue, use isopropyl alcohol to ensure a spotless finish. Test the decal placement by holding it against the surface and if needed, use masking tape to mark alignment points.

Optimal installation temperatures are between 15°C and 35°C. If it's colder and you understandably really don't want to wait, you can use a hair dryer to slowly and carefully warm up the surface a bit for better adhesion.

Peel the Backing Paper:

• Lay the decal flat on a clean surface. Carefully peel the backing paper from the decal, leaving the decal adhered to the transparent transfer tape. Try not to touch the adhesive transfer tape more than needed to hold it.

Position the Decal:

• Align the decal on the car's surface. If you need extra precision, use masking tape as a guide.

Adhere the Decal:

• Press the decal onto the surface, starting from the center and working outward. Use your hand to ensure initial adhesion, then smooth the surface firmly with a squeegee or a cloth-wrapped credit card to remove air bubbles.

Remove the Transfer Tape:

• Once the decal is securely applied, slowly peel off the transfer tape at a sharp angle (close to the surface). Pull gently to avoid lifting the decal and watch it closely. If any part of the decal lifts, press it back down and re-smooth it with the squeegee.

Smooth Out Bubbles:

• Inspect the decal for any air bubbles. Small bubbles can be pressed out toward the edges with a squeegee. For stubborn bubbles, use a pin or blade to puncture them gently and press out the trapped air.

You did it! Great job!